 |
        |
|
|
|
SKS Trigger - Disassembly
|
|
 Make sure the SKS is unloaded and the safety is on Remove trigger group by depressing the tab indicated by the white line
|
 Complete trigger assembly.
|
 WARNING - Control the hammer or risk a very sore finger Uncock the hammer by disengaging the safety then pulling back on the trigger and pushing down on the disconnector, control the hammer as it springs forward
|
 Depress the mag cover latch (35) and remove the latch stop pin (38) This will allow you to remove the magazine cover latch (35), latch / sear spring (36), and sear (37).
|
Compress the hammer
spring ( 54) by hand, this will take some effort, and lift out the hammer
(51)
|
 |
| Raise the disconnector (49) and
remove the rebound disconnector (50) by squeezing it
together to separate it from the trigger guard (39) and lifting it out.
|
 Using a 3/32 punch (or maybe a rusty nail... if you've had a recent tetanus shot) remove the disconnector hinge pin (40) and lift out the disconnector (49).
|
 Use the 3/32 punch to remove the trigger pin (41) and lift out the trigger (44), trigger bar (46), and safety catch spring.
|
 With the 3/32 punch remove the trigger bar pin (47) to separate the trigger (44), trigger bar (46), and safety catch spring.
|
 Finally, use the 3/32 punch to remove the safety catch pin (45) and remove the safety catch (42).
|
|
on to Trigger - improvement |
