MN Sporter
Polish the trigger components

The trigger system on a MN is very basic and there isn't a lot you can do to improve it, except to smooth things up a bit. The trigger assembly is held on by a single screw on the bottom of the receiver.

Use 400-600 grit sand paper to polish the trigger pin and the areas indicated with the lines where the spring and trigger contact each other.

Polish both sides of the trigger as indicated below, and of course do the same on the mounting lugs on the receiver. Coat all parts with some quality grease before you reassemble.

On to next step
Mosin-Nagant Sporter Project Index
Back